Predator 212cc throttle hookup

predator 212cc throttle hookup

How do I install the predator 212cc throttle kit?

This is a basic throttle kit for the Predator 212cc. The governor will not be affected by this. Assemble the kit as shown. When threading the bolts in, move your wrench or ratchet in either direction a few times, this should make the threading easier. Start by removing the air box assembly, remove the tube from the gas tank.

Is the predator 212cc a good engine?

However, it has been blurred since the inception of the predator 212cc engine. The Chinese predator 212cc is not only cheap but also reliable. This predator engine has given karters a new and complete world. You can easily upgrade them to boost their performance. This is one of the reasons for their dominating.

How to install a throttle kit?

Start installing the throttle kit by positioning the rod into the cable/rod clamp. Now reinstall the two recoil housing bolts (without the washers). Install the cable through the fitting and into the aluminum cable clamp.

How do I adjust the tension on my throttle cable?

Feed the cable through the top and out the side - you can bend the end of the cable slightly to persuade it to come out the side youd like. This is where you will also set your tension for throttle adjustment, and the throttle rod will be fastened when you adjust your cable tension.

How to install a throttle kit?

Start installing the throttle kit by positioning the rod into the cable/rod clamp. Now reinstall the two recoil housing bolts (without the washers). Install the cable through the fitting and into the aluminum cable clamp.

How do I remove the throttle control from the throttle?

***With a 10mm socket or wrench slightly loosen (about 1/4 turn on) the yellow center nut holding the throttle control. This should to be able to move freely now. Remove the conduit retainer (red circle) and set aside - its no longer needed.

How do I adjust the tension on my throttle cable?

Feed the cable through the top and out the side - you can bend the end of the cable slightly to persuade it to come out the side youd like. This is where you will also set your tension for throttle adjustment, and the throttle rod will be fastened when you adjust your cable tension.

How do I adjust the throttle cable on my throttle?

Move the throttle into the neutral position. Pull the throttle cable to its attachment point on the throttle. Adjust the cable by moving it until it lines up exactly with the attachment point.

Are there any adjustments for throttle friction?

I do not know if there are adjustments for throttle friction. On my old MerControl (vintage 77) there are no adjustments, however, you may have them. The good news is that the throttle cable will start to get a bit stiff as it gets dirty and worn. This will minimize the need for the adjustment. You may be right.

What does a tight throttle cable mean?

a tight throttle cable means youve got no deadspot, the first 10mm of travel might be free play on a slack cable. Once adjusted it immediately opens the throttle valve.

What should I do if my throttle control fails?

If your boat and motor are still under warranty, dont attempt to adjust the throttle cable; take the boat to the dealer as soon as possible. Dont attempt to operate your boat with a failed throttle control; serious injury or death may result.

Related posts: